Epson 1440 - Manual (Page 26)

Section 3: Installing and Configuring the Print Server
16 AXIS 1440 User’s Manual
Installation and Setup Overview
Now you’re ready to install and configure the AXIS 1440 for your
network. The steps you perform depend on your network protocol
and the operating systems on your network. The table on the
following page provides guidelines specific to different network
requirements.
Here is a setup overview:
1. Set up the AXIS 1440 Print Server for your network.
2. Install the AXIS software on server workstations, if setting up a
shared printer. (See Software Installation on page 18 for
installation instructions.)
3. Install the AXIS software on client workstations printing in peer-
to-peer mode.
4. Configure each workstation’s printer port to use the AXIS 1440
Print Server.
Note: ❏ This setup overview assumes that you’ve already done the
following:
• Set up your EPSON printer and installed the printer software
on each computer that will print over the network.
• Attached the AXIS 1440 Print Server to your printer and con-
nected it to the network.