Enterasys Networks Fast Network 10 - Manual (Page 46)

Chapter 3: Configuring Your FN10
Page 3-4 Fast Network 10 User Guide
3.1.1 Displaying IP Addresses
To display IP addresses, subnet masks, and MAC addresses of all ports on
the FN10 you are configuring, at the LCM prompt:
1. Type ipaddr
LCM displays the current IP address table, for example:
3.1.2 Deleting an IP Address
To delete an IP address, at the LCM prompt:
1. Type ipaddr 0.0.0.0
LCM responds by redisplaying the current IP address table.
3.1.3 Changing a Subnet Mask
You can optionally set the subnet mask for a port. A subnet mask is a
32-bit address mask used in IP to specify a particular subnet. If the subnet
mask is 0.0.0.0, the FN10 will automatically convert the displayed mask
to the standard default, based on the port’s IP address class. (Class A
address masks are 255.0.0.0, Class B address masks are 255.255.0.0,
Class C address masks are 255.255.255.0.)
To change the subnet mask, at the LCM prompt:
1. Type ipaddr
For example, ipaddr 6 192.138.217.40 255.255.240.0 would set the
subnet mask for port 6 to 255.255.240.0. LCM responds by
redisplaying the current address table.
IP Address Address Mask MAC Address
1
2
3
4
5
6
7
8 192.138.217.1
0.0.0.0
192.138.217.10
0.0.0.0
0.0.0.0
192.138.217.20
192.138.217.50
192.138.217.30 255.255.255.0
255.0.0.0
255.255.255.0
255.0.0.0
255.0.0.0
255.255.255.0
255.255.255.0
255.255.255.0 00:40:27:00:06:1f
00:40:27:00:06:c3
00:40:27:00:06:3e
00:40:27:00:03:7a
00:40:27:00:05:c7
00:40:27:00:04:4a
00:40:27:00:06:9e
00:40:27:00:04:b4
Port