Powerplus POWXQ5360 TABLE SAW 1800W 254MM EN - Manual (Page 9)

POWXQ5360 EN
Copyright © 2010 VARO P a g e | 9 www.varo.com
Fig 6
Place the open-ended blade wrench (f) on the flat of
the outer flange (c) in order to prevent the arbor from
turning while tightening.
Tighten the arbor nut by turning it clockwise using the
box-end blade wrench (g)
Verify that the saw blade, the arbor flange, and the nut are properly seated,
and that the arbor nut is tightened securely.
In order to avoid injury from an accidental start-up, verify that the power
switch is in the “off” position, and that the power cord is not plugged into
the outlet.
8.4 Assembling the blade guard (fig 7, fig 8, fig 9)
Fig 7
 Use the hand wheel to set the blade to the
maximum height and to set the tilt to 0° on
the bevel scale. Lock the blade with the
bevel locking knob.
 After loosening the knob (c), press the
device (a), the splitter (b) should be at the
highest position.
Fig 8
 Insert the blade guard assembly (d) into
the splitter bracket, as shown.
 Using a straight edge (f), verify whether
the blade guard splitter (e) is aligned with
the saw blade (g), with the straight edge
lying between the teeth of the blade.