Powerplus POWXQ5360 TABLE SAW 1800W 254MM EN - Manual (Page 14)

POWXQ5360 EN
Copyright © 2010 VARO P a g e | 14 www.varo.com
9.2.2 Switching Off
 Press the red EMERGENCY OFF button (a) or the red O-push button (d).
9.3 Overload protection (fig 18)
Fig 18
This saw is equipped with a reset overload relay
button (a). It is situated at the immediate right of the
paddle switch. The reset button will restart the motor
after it shuts off due to overloading or low voltage.
If the motor stops during operation, move the ON/OFF
paddle switch to the OFF position. Wait approximately
five minutes for the motor to cool down and push the
reset button (a). Now you can switch to the ON
position again.
In order to avoid injury and prevent accidental start-up when the reset
button is pushed, the on/off paddle switch should be in the off position, and
the power cord should be unplugged from the outlet while the saw is
cooling down. Overheating may be caused by an under-sized extension
cord, an extension cord that is too long, misaligned parts, or a dull blade.
inspect the saw for proper set-up before using it again.
9.4 Using the table extension wings (fig19, fig 20)
Fig 19
Fig 20
 Unlock the table extension wing levers (a) underneath the main table.
 Slide the extension tubes in or out until the scale on the tube is positioned at the desired
distance. Lock the table extension wing levers (a).
 To adjust the position of the rip fence, loosen the locking handle (c), and place the
auxiliary aluminum fence (d) in position by using the calibration point in red (b).
 Tighten the locking handle (c).
a
a
a
b
c
d