Powerplus POWXQ5360 TABLE SAW 1800W 254MM EN - Manual (Page 16)

POWXQ5360 EN
Copyright © 2010 VARO P a g e | 16 www.varo.com
9.6 Bevel ripping (fig 22)
Fig 22
Bevel ripping is the same as ripping, except that the blade bevel angle is set to an angle other
than “0”.
The workpiece and the fence must be on the right side of the blade when
cutting.
9.7 Ripping small pieces
Avoid injury caused by contact with the blade. Do not use this saw to make
through-cuts that are
narrower than 1/2” (13 mm).
 It is not safe to rip small pieces. Instead, rip a larger piece in order to obtain the size of the
desired piece.
 When ripping a small work piece, it is not safe to place the hand between the blade and
the rip fence. Use one or more push sticks to push the work piece completely past the
blade.
9.8 Crosscutting (fig 23, fig 24)
Fig 23