Powerplus POW8041 MITRE SAW +UPPER TABLE 1200W 210MM EN - Manual

POW8041 EN
Copyright © 2014 VARO P a g e | 1 www.varo.com
1 APPLICATION .................................................................................. 3
2 DESCRIPTION (FIG 1 & 2) .............................................................. 4
3 PACKAGE CONTENT LIST ............................................................. 4
4 SYMBOLS ........................................................................................ 5
5 GENERAL POWER TOOL SAFETY WARNINGS .......................... 5
5.1 Working area ........................................................................................................... 5
5.2 Electrical safety ....................................................................................................... 5
5.3 Personal safety ....................................................................................................... 6
5.4 Power tool use and care ......................................................................................... 6
5.5 Service ..................................................................................................................... 7
6 BEFORE PUTTING THE MACHINE INTO OPERATION (FIG. 1-3)7
6.1 General information ................................................................................................ 7
6.2 Converting the combination saw ........................................................................... 7
6.2.1 Converting the saw to mitre box mode ...................................................................... 7
6.2.2 Converting the saw to bench-type circular saw mode ................................................ 7
7 OPERATION (FIG. 1-9) .................................................................... 8
7.1 Using as a bench-type circular saw ....................................................................... 8
7.1.1 On/Off switch (Fig. 4) ................................................................................................ 8
7.1.2 Adjusting the cutting depth (Fig. 2) ............................................................................ 8
7.1.3 Making longitudinal cuts (slitting) (Fig. 4) ................................................................... 8
7.1.4 Making cross cuts (Fig. 8/9) ...................................................................................... 9
7.2 Using as a mitre box saw ....................................................................................... 9
7.2.1 Settings (Fig. 2/3) ...................................................................................................... 9
7.2.2 On/Off switch {Fig. 2) ................................................................................................ 9
7.2.3 90° cross-cuts and 0° rotary table (Fig. 2) ................................................................. 9
7.2.4 90° cross-cuts and 0°-45° rotary table (Fig. 10) ....................................................... 10
7.2.5 Mitre cuts 0a-45D and rotary table 0* (Fig. 11/12) ................................................... 10
7.2.6 Mitre cuts 0°-45* and rotary table 0fl-45fl (Fig. 11/13) .............................................. 10
7.2.7 Chip extractor (Fig. 12) ........................................................................................... 10
8 REPLACING THE SAW BLADE (FIG. 14/15) ............................... 10