Powerplus POWXQ5360 TABLE SAW 1800W 254MM EN - Manual (Page 7)

POWXQ5360 EN
Copyright © 2010 VARO P a g e | 7 www.varo.com

lead from lead-based-painted material and,

arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To
reduce your exposure to these chemicals: work in well ventilated area and work with approved
safety equipment, such as those dust masks that are specially designed to filter out
microscopic particles.
 Use push stick or push block to avoid working with the hands and fingers close to the saw
blade.
 Always store the push-stick when it is not in use.
 Place a stable support under long workpieces. This allows you to prevent the instability of
the tool.
7 GUIDELINES FOR USING EXTENSION CORDS
 Make sure the extension cord is in good condition. When using an extension cord, be sure
to use one that is heavy enough to carry the current that your product will draw. An
undersized cord will cause a drop in line voltage, which will result in loss of power and
overheating.
 Make sure your extension cord is properly wired and in good condition. Always replace a
damaged extension cord, or have it repaired by a qualified person before using it. Protect
your extension cords from sharp objects, excessive heat, and damp or wet areas.
 Before connecting the motor to the power line, make sure the switch is in the OFF position
and the electric current is rated the same as the current stamped on the motor nameplate.
Running at a lower voltage will damage the motor.
This tool must be grounded while in use in order to protect the operator
from electric shock.
8 ASSEMBLY
8.1 Rip fence (fig. 1)
Fig 1
 Lift the rip fence handle (a) until the
rear holding clamp (b) is fully
extended.
 Place the rip fence on the saw table,
lowering the rear of the fence onto the
table first.
 Push down the rip fence handle (a) in
order to lock the rip fence in position.
a
b