Installing the blade (fig 4, fig 5, fig 6) – Powerplus POWXQ5360 TABLE SAW 1800W 254MM EN User Manual

Page 8

POWXQ5360

P a g e

| 8

www.varo.com

8.2

Auxiliary rip fence (fig. 2, fig 3)

Fig 2

When sawing narrow work pieces and for
bevel cuts, the auxiliary rip fence (a)
(aluminum) must be mounted to the rip fence.
 Insert the profile rail (b) into the groove on

the short side of the auxiliary rip fence.

 Position the profile rail (b) in front of the rip

fence in such a manner that the holes of
both parts are in alignment.

 Insert the fastening knobs through the

lateral holes in the rip fence and tighten
them.

Fig 3

When sawing high, narrow work pieces, the
auxiliary rip fence (aluminum) must be
mounted directly to rip fence (d).
 Fasten the auxiliary rip fence (a) with the 2

square nuts and the fastening knobs (c)
directly to the rip fence (d).

8.3

Installing the blade (fig 4, fig 5, fig 6)

Fig 4

Unscrew the 6 screws (a) in the table insert. Remove
the table insert by using your spanner to lift it.

Fig 5

 Raise the saw blade arbor (e) to its maximum

height by turning the blade raising control handle
counter-clockwise. Remove the arbor nut (b) and
the outer flange (c) from the saw arbor.

 Place the saw blade onto the arbor, with the teeth

of the blade pointing DOWN toward the front of the
saw.

 Place the flange (c) and the arbor nut (b) onto the

arbor, and hand-tighten the nut. Verify that the saw
blade is firmly seated against the inner flange (d).

 NOTE: Verify that the large, flat surfaces of the

flange and the nut face INWARD, toward the saw
blade.