Powerplus POWXQ5360 TABLE SAW 1800W 254MM EN - Manual (Page 11)

POWXQ5360 EN
Copyright © 2010 VARO P a g e | 11 www.varo.com
8.6.2 Rear extension table
 Unscrew the screws (a) at the end of both extension tubes.
 Install the rear extension table by sliding the tubes into the 2 holes (b) at the back of the
main table.
 Replace the screws (a) back into the tubes to prevent you from pulling the rear extension
table too far out.
 You can lock at the wanted position with the 2 locking knobs (c) at the bottom of the main
table.
8.7 Installing the miter gauge (fig 12)
Fig 12
Insert the guide rail (a)
of the miter gauge into
one of the guide grooves
(b) of the saw table
intended for this
purpose.
8.8 Adjusting the miter gauge (fig 13)
Fig 13
 Loosen the locking handle (b) in order to allow the
miter body (c) to rotate freely. Position the miter
body at 90° so that the positive detent secures it in
position. Tighten the locking handle in order to
hold the miter body securely in position.
 If the pointer (a) requires adjustment, loosen the
screw that is located under the pointer using a
screwdriver. Adjust the pointer to 90° on the scale,
and then tighten the adjusting screw firmly.
 In order to change the angle of the miter gauge,
loosen the locking handle (b) and the rotate the
miter body to the desired angle, as indicated on
the scale. Tighten the locking handle in order to
hold the miter body securely in position.
a
b
b