Powerplus POWXQ5360 TABLE SAW 1800W 254MM EN - Manual (Page 15)

POWXQ5360 EN
Copyright © 2010 VARO P a g e | 15 www.varo.com
9.5 Ripping (fig 21)
Fig 21
 Remove the miter gauge, and secure the rip fence to the table.

Raise the blade until it is approximately 1/8” (3.2 mm) above the top of the work piece.
 Place the work piece flat on the table and against the fence so that the larger portion of
the work piece is between the blade and the fence. Keep the work piece approximately 1”
(2.5 cm) away from the blade.
 Turn the saw ON, and wait for the blade to reach full speed.
 Slowly feed the work piece into the blade by pushing forward on the section of the work
piece that will pass between the blade and the fence
 Do not place your thumbs on the table top. Always hold the work piece while the blade is
turning. Do not let go of it in order to reach for the push stick. When both thumbs touch the
front edge of the table, complete the cut using a push stick.
 Always use the push stick when performing ripping operations.
 Continue to push the work piece with the push stick until it passes the blade guard and
clears the rear of the table.
 Do not pull the work piece backward while the blade is turning. Turn the switch OFF, and
unplug the power cord. Wait until the blade comes to a complete stop and slide the work
piece out.