Bang & Olufsen BeoSystem 4 with Beo4 User Guide - Manual (Page 58)

58
If you have placed your television
in a room where you already
have a Bang & Olufsen television,
and commands from your
remote control can be received
by both televisions, you must
change the Option setting for
one of the televisions. This
prevents simultaneous activation
of both televisions.
The television connected to
BeoLink Converter NL/ML must
be in Option 1 or 2 and the other
television must be changed to
Option 4.
Option setting of your television
is done via the PRODUCT
INTEGRATION menu,
see page
56 . Note that if the television is
set to Option 4 in the television
menu and you use a Beo4
remote control, you must press
LINK and then select a source
on Beo4.
If you have more than one remote
control and a specific Beo4 is always
used for the television set to Option 4,
you can set up the Beo4 to send
commands to this television without
pressing LINK first. Find ZONE in the
Beo4 setup menu and select LINK.
One remote control for both televisions
For your television to function properly,
it is essential that the television is set to
the correct Option.
See page 56 .
Beo4 – Operate your television in
Option 4 …
Normally, you can activate a source, such
as TV, simply by pressing the relevant
source button on your remote control.
However, when you set your television
to Option 4, you must do the following,
if you have a Beo4:
Press to bring up LINK in the
Beo4 display
Press a source button, such as TV
Two televisions in the same room
LIST
LINK
TV
TV
LIST
LINK
TV
Zone ‘B’
TV
Zone ‘A’
TV
For information about choice of zone,
contact your retailer.