Bang & Olufsen BeoSystem 4 with Beo4 User Guide - Manual (Page 12)

12
>> Connections
Connect speakers to the system
You can connect up to 12 speakers and
subwoofers to the system.
Disconnect all systems from the mains
before you connect additional
equipment.
Depending on the type of equipment you
connect to the system, different cables and
maybe also adaptors are needed. Cables and
adaptors are available from your Bang &
Olufsen retailer.
Connect speakers
> Connect a Power Link cable to the
appropriate socket on the speakers you
wish to connect to the system.
> Run the cables to available sockets marked
PL 1–6 on the system.
> Run a Power Link cable between the
appropriate sockets on additional speakers,
if available.
> Connect a Power Link cable to the
appropriate socket on a subwoofer.
> Run the cable to an available socket
marked PL 1–6 on the system.
> Reconnect the system and the connected
equipment to the mains.
To connect two speakers to one PL socket, a
special cable is needed. If it is not possible to
loop the cable between two speakers, an
extra splitter is needed, contact your Bang &
Olufsen retailer for more information.
CTRL 1 CTRL 2 CTRL 3
PUC 3 A+B PL 1 PL 2 PL 3
EXT IR PUC 1
A+B
CTRL 4
PUC 2
A+B
CTRL 5
NOT
USED
PL 4 PL 5
1 2 3 4 5
HDMI IN
AV
IN
S/P-DIF
IN
5V
0,5A
12V=1.0A
STAND
COMMON INTERFACE
CHIPSIDE
CHIPSIDE
5V=50mA
AERIAL
14/18V=0.4A
SATELLITE
HDMI
OUT
MONITOR
CONTROL
IR/AUTO
CONTRAST
PL 6
Example of a speaker setup.
Rear speaker
Rear speaker
Subwoofer
Front speaker Front speaker