Bang & Olufsen BeoSystem 4 with Beo4 User Guide - Manual (Page 15)

15
Set up a display
When you connect a television
screen or a projector to your
system, you can set up the
screen or projector in the
DISPLAY SETUP menu, if it is not
detected automatically.
Registering the television screen or
projector connected to the system
enables you to operate it with your
Beo4/Beo6 remote control.
If your television screen is detected
automatically, the DISPLAY SETUP menu
displays the name of the screen. If the
screen or projector is not detected
automatically, you must select the type of
display to configure. Use the navigation
button left and right to switch between the
list of names for television screens and
projectors. Follow on-screen instructions to
configure the display.
Download a PUC table
If the name of the television screen or
projector is not in the list, select
DOWNLOAD MORE. Follow on-screen
instructions to download a Peripheral Unit
Controller (PUC) table if available.*
1 The
television must be connected to the Internet.
If your connected television screen or
projector is not on the download list, there
is currently no control solution for it and you
must select UNSUPPORTED SCREEN or
UNSUPPORTED PROJECTOR. You will not be
able to operate your television screen or
projector with your Beo4/Beo6 remote
control and picture parameters are set to
neutral values. Contact a Bang & Olufsen
retailer for more information.
You can search with Latin characters and
numbers. For equipment names with non-
Latin characters you can search for a part of
the name that includes Latin characters. You
can also use the browse functions to locate
the correct PUC table.
1 *If you use a Beo4 remote control, you may
have to switch on your projector or
television screen using SHIFT + 9. SHIFT can
be found in the Beo4 LIST.
Register your television screen or projector
MENU
SETUP
DISPLAY SETUP
…