Bang & Olufsen BeoSystem 4 with Beo4 User Guide - Manual (Page 29)

29
Calibrate colour accuracy of the screen
When you press the standby button to
switch off the television after
approximately 100 hours of use since the
last calibration, a calibration process
begins and a sensor arm swings out
from the television frame. When the
calibration has finished, the sensor arm
retracts and the television switches off.
If your television screen is
equipped with the Automatic
Colour Management, it
automatically compensates for
colour changes on the screen
approximately every 100 hours
of use, ensuring perfect colours
continuously. It is possible to
activate the calibration feature
manually, however, we
recommend that calibration is
performed automatically.
Do not switch off your television or
disconnect it from the mains during the
calibration.
Automatic calibration
The Automatic Colour Management is
available in the menu, when the
television is in tele vision mode and has
been switched on for more than two
minutes.
All text is removed from the menu, the
sensor arm swings out from the television
frame and the calibration begins. The on-
screen field changes between various
colours. When the calibration has finished,
the bar is removed, the sensor arm retracts,
the television returns to the last chosen
source, and ‘CALIBRATION COMPLETE’ is
displayed for a few seconds.
If the sensor arm does not swing out fully,
the calibration is not performed and the arm
is retracted. If the calibration is initiated
automatically, the television will attempt to
execute the calibration the next time it is
switched off. Contact your Bang & Olufsen
retailer if the problem persists.
Manual calibration
MENU
SETUP
PICTURE
PICTURE ADJUSTMENT
ADVANCED SETTINGS
AUTO COLOUR MANAGEMENT