Lanner LEC-7100 - Manual (Page 9)

6
Introduction
Chapter 2
Embedded and Industrial Computing
Note:
To remove the module from the system, release 1.
the latch first by slightly bending it inward.
To remove the SIM card, unlock the tray first by 2.
sliding it outward.
Wall Mounting
The product ships with wall mounting kit. To mount your
product on the wall, follow the instructions below:
First make a hole for the anchor in the surface on the 1.
wall.
Then press the anchor into the hole until it is flush with
2.
the surface. You may need a hammer to tap the wall
anchor.
Use a screwdriver to screw the threaded screw into the
3.
plastic anchor.
Attach the wall mounting bracket to the back of the
4.
device, securing it in place with four of the flat-head
screws provided.
Hang the device on the wall.
5.
Installing a CompactFlash Card
LEC-7100 provides one CompactFlash slot(CF1). Follow
the procedures bellow for installing a CompactFlash card.
Align CompactFlash card and the card slot with the 1.
arrow pointing toward the connector.
Push the card to insert into the connector.
2.
3G SIM Card Installation
Open the SIM tray and flip it diagnolly. 1.
Align the cut-off angle of the SIM card with the SIM 2.
card socket. Also place the ICs facing up.
Insert the
3. SIM card into the tray diagnoally. Close and
lock the tray.
Wireless 3G module Installation
Align the wireless module’s cutout with the Mini-PCIe 1.
slot notch.
Insert the wireless module into the connector
2.
diagnoally.
Push the other end of the wireless module to be
3.
tightened with the latch.
1
2
3
SIM Card
2
2
3G module