Lanner LEC-7100 - Manual (Page 26)

23
Bios Settings
Chapter 4
Embedded and Industrial Computing
Remote Access Configuration
You can use this screen to select options for the Remote
Access Configuration. Use the up and down keys
to select an item. Use the and keys to
change the value of the selected option. The settings are
described on the followingpages. The screen is shown at
the right.
Remote Access
You can disable or enable the BIOS remote access feature
here.
Option Description
Disabled Set this value to prevent the BIOS from using
Remote Access..
Serial Set the value for this option to Serial to allow
the system to use the remote access feature.
The remote access feature requires a dedicated
serial port connection.
Serial Port Number
Select the serial port you want to use for console
redirection. You can set the value for this option to either
COM1 or COM2.
Option Description
115200 8,n,1 Set this value to allow you to select 115200 as
the baud rate (transmitted bits per second) of
the serial port.
57600 8,n,1 Set this value to allow you to select 57600 as the
baud rate (transmitted bits per second) of the
serial port.
19200 8,n,1 Set this value to allow you to select 19200 as the
baud rate (transmitted bits per second) of the
serial port
Note: For instructions of setting up the remote
access on the client program, refer to Appendix B
Setting up the Remote Access.
ACPI Aware O/S
Option Description
No This setting should be set if the operating
system in use does not comply with the
ACPI (Advanced Configuration and Power
Interface) specification. DOS®, Windows
3.x®, and Windows NT® are examples of
non-ACPI aware operating systems.