Lanner LEC-7100 - Manual (Page 33)

30
Setting up Remote Access
Appendix B
Embedded and Industrial Computing
Appendix B:
Setting up Remote Access
Remote Access lets you monitor and configure a system
from a remote terminal computer by re-directing
keyboard input and text output through the serial port.
This following steps illustrate how to use this feature.
Connect one end of the console cable to console port 1.
of the system and the other end to serial port of the
Remote Client System.
Configure the following settings in the BIOS Setup
2.
menu for LEC-7100:
BIOS > Advanced > Remote Access Configuration >
Serial Port Mode > [9600, 8 , n ,1 ]
Configure Console Redirection on the client system. 3.
The following illustration is an example on Windows
platform:
A. Click the start button, point to Programs > a.
Accessories > Communications and select Hyper
Terminal.
B. Enter any name for the new connection and
b.
select any icon.
Click OK.
c.
From the “Connect to”. Pull-down menu, select the d.
appropriate Com port on the client system and
click OK.
Select 9600 for the Baud Rate, None. for Flow
e.
contorl, 8 for the Data Bit, None for Parity Check,
and 1 for the Stop Bit.
Note: You will have to enable and configure
this feature on the BIOS. Please refer to Remote
Access on Chapter 4 BIOS Settings.