Yaskawa P7 Drive User Manual - Manual (Page 199)

Parameters A - 25
Monitor List
Table 2: Monitor List
Parameter
No.
Parameter Name
Digital Operator Display
Description
Monitor
U1-01
Frequency Reference
Frequency Ref
Frequency reference (speed command) monitor when in auto
mode, frequency reference (speed command) setting location when
in hand mode. Units changeable via o1-03.
U1-02
Output Frequency
Output Freq Output frequency (speed) monitor. Units changeable via o1-
03.
U1-03
Output Current
Output Current
Output current monitor
U1-06
Output Voltage
Output Voltage
Displays Drive output voltage
U1-07
DC Bus Voltage
DC Bus Voltage
Displays DC Bus Voltage
U1-08
Output Power
Output kWatts
Displays Drive output power
U1-10
Input Terminal Status
Input Term Sts
Displays Drive input terminal status
U1-11
Output Terminal Status
Output Term Sts
Output terminal ON/OFF Check
U1-12
Drive Operation Status
Int Ctl Sts 1
0
1: FWD. run
(Terminal S1) is ON.
1: REV. run
(Terminal S2) is ON.
1: Multi-function input 1
(Terminal S3) is ON.
1: Multi-function input 2
(Terminal S4) is ON.
1: Multi-function input 3
(Terminal S5) is ON.
1: Multi-function input 4
(Terminal S6) is ON.
1: Multi-function input 5
(Terminal S7) is ON.
0 0 0 0 0 0 0
1: Multi-function Contact 1
output 1 (Terminal M1-M2)
is ON
1: Multi-function Contact 2
output 1 (Terminal M3-M4)
is ON
Not used
1: Fault output
(Terminal MA/MB-MC) is
ON
0 0 0 0 0 0 0 0
1: During running
1: During zero speed
1: During reverse
1: During reset signal input
1: During speed agree
1: Drive operation ready
1: During fault detection
(Minor fault)
1: During fault detection
(Major fault)
0 0 0 0 0 0 0 0