Yaskawa MP940 Hardware Manual - Manual (Page 18)

MotionSuite™ MP940 Machine Controller Hardware Manual Section 3: DIP Switch Definition
15
Section 3: DIP Switch Definition
The function of the six switches is explained in the table below.
DIP Switch Settings
Number Name Setting Function
Default
Setting
6 RUN ON Application program runs at power ON ON
OFF Application program does not run at power ON
5 INIT ON When DIP switch 4 is OFF:
Data is copied from flash memory to RAM at power ON.
When DIP switch 4 is ON:
Memory is cleared.
OFF
OFF When DIP switch 4 is OFF:
Data is not copied from flash memory to RAM at power ON.
When DIP switch 4 is ON:
Nothing
4 TEST ON Terminal Mode/Initialization Mode OFF
OFF Online
3 FLASH ON Program is copied from flash memory to RAM at power ON. OFF
OFF Program is not copied from flash memory to RAM at power ON
2 Programming
Port Default ON Defaults to Port 1 only OFF
OFF The programming port is set up through software selection
1 COPY ON Global variables are copied from flash at power ON OFF
OFF Global variables are not copied from flash at power ON.
Figure 3.1: MP940 DIP Switches
NO
1
2
3
4
5
6
←
RUN
INITIAL
TEST
FLASH
P.P
COPY