Yaskawa G5 Eliminator - Manual (Page 22)

Date: 07/01/04, Rev: 04-07 Page 22 of 27 TM.G5SW.015
Parameter 3
P1-03 = 0
P1-03 Parameter 3 B B B B
This parameter is provided for user input. Refer to section 2.1.3.
Parameter 4
P1-04 = 0
P1-04 Parameter 4 B B B B
This parameter is provided for user input. Refer to section 2.1.3.
Parameter 5
P1-05 = 0
P1-05 Parameter 5 B B B B
This parameter is provided for user input. Refer to section 2.1.3.
Diam Filter Time
P1-06 = 0.1 sec
P1-06 Diameter Filter Time B B B B
The Diam Filter Time controls the rate of change within the winder filter. Refer to section 2.2.6.
Diam Bld Ratio
P1-07 = 0.1
P1-07 Diameter Build Ratio B B B B
The Diam Build Ratio is the number equal to the ratio of core diameter to maximum roll
diameter. Refer to section 2.2.6.
Example:
Core Diameter = 4”
Max Roll Diameter = 48”
Set P1-07 = 48” / 4”‘or 12
Setting Range: 0 to 65535
Factory Default: 0
Modify During Run: Yes
Modbus Address: 0582H
Setting Range: 0 to 65535
Factory Default: 0
Modify During Run: Yes
Modbus Address: 0583H
Setting Range: 0 to 65535
Factory Default: 0
Modify During Run: Yes
Modbus Address: 0584H
Setting Range: 1 to 50 sec
Factory Default: 0.1 sec
Modify During Run: No
Modbus Address: 0585H
Setting Range: 0.1 to 50
Factory Default: 0.1
Modify During Run: No
Modbus Address: 0586H