SMA SB 700 - Manual (Page 29)

SMA Technologie AG Installation
Installation Guide SB700-11:SA2006 Page 29
To adjust the input voltage, follow these steps:
1. Open the Sunny Boy 700 as described in section 6.1.
2. Pull the terminal upwards out of the terminal block and plug it into the
appropriate slot.
3. Plug the jumper provided in the accessories kit into the corresponding slot on the
controller board. If you want to use the Sunny Boy 700 with the maximum input
voltage range, then do not use the jumper.
4. Once the jumper is in place and the terminal plugged into the correct slot, close
the Sunny Boy 700 as described in section 6.2.
There is a schematic view of the connectors in the table below.
Voltage range Terminal block Jumper
119 ... 250 V DC
(factory setting)
96 ... 200 V DC
73 ... 150 V DC
Terminal in
slot 1
150V ENS2 200V ENS1
No jumper used
Terminal in
slot 2
150V ENS2 200V ENS1
Jumper fitted to
"200 V" position
Terminal in
slot 3
150V ENS2 200V ENS1
Jumper fitted to
"150 V" position