SMA SB 700 - Manual (Page 23)

SMA Technologie AG Installation
Installation Guide SB700-11:SA2006 Page 23
5. Now screw the threaded sleeve onto the socket element and tighten it.
6. Now screw the pressure screw into the
threaded sleeve and tighten it. The cord grip
with the sealing ring is pressed into the
threaded sleeve and can no longer be seen.
The AC connecting socket is now fully assembled.
If you are not going to connect up the Sunny Boy immediately, close off the socket
element using the cap supplied in the accessories kit.
If the Sunny Boy is already installed, you can now connect up the fully assembled AC
connection socket to the flange plug on the Sunny Boy. To do this, remove the
protective cap from the flange plug on the Sunny Boy. Firmly tighten the threaded
ring on the AC connecting socket to the flange plug to seal the connection and secure
it.
Do not switch the line circuit breaker on yet! The Sunny Boy 700
may only be connected to the AC grid once the PV strings are
connected and the device is securely closed.
Cord grip with
sealing ring
Pressure screw
Threaded sleeve
screwed
onto socket element
Pressure screw