SMA SB 700 - Manual (Page 14)

Installation requirements SMA Technologie AG
Page 14 SB700-11:SA2006 Installation Guide
When choosing the installation site, be sure to note the
following:
When choosing the installation site, ensure there is enough space for heat to
dissipate. Under normal conditions, the following guidelines should be applied for
the space to be kept clear around the Sunny Boy 700:
In domestic installations, the unit should not be
mounted on plasterboard walls or similar as otherwise
audible vibrations are likely to result.
We recommend securing the unit to a solid surface.
The Sunny Boy 700 will emit a slight noise during
operation. This noise can be annoying when the Sunny
Boy is installed within a living area.
Unintentionally pulling out the DC plug connector under load can
damage the plug and result in bodily injury or death! Install the
Sunny Boy in such a way that it is not possible (e.g. for children) to
unplug the DC plug connector unintentionally.
Individual components in the Sunny Boy can reach a temperature
of more than 60 °C.
Do not install the Sunny Boy on flammable construction materials,
in areas where highly inflammable materials are stored or in
potentially explosive environments!
Minimum clearance
Sides 20 cm
Top 20 cm
Underneath 20 cm
In front 5 cm Betrieb
Operation
Erdschluss
Earth Fault
Störung
Failure Photovoltaik-Stringwechselrichter
Photovoltaic string inverter
20
cm
20
cm
20 cm 20 cm
5
cm