SMA Sensorbox - Manual (Page 59)

SMA Solar Technology AG Startup
Installation Guide Sensorbox-IEN100914 59
Power from the Power Module
You can use the power module from SMA Solar Technology AG as an alternate power source for the
SMA Power Injector with Bluetooth.
To do so, proceed as follows:
1. Install the power module into the inverter as described in the power module installation guide.
2. Connect the plug of the SMA Power Injector with Bluetooth to the pre-assembled power cable
of the power module.
3. Insert the plug into the connection terminal of the alternate power supply for the SMA Power
Injector with Bluetooth.
☑ The SMA Power Injector with Bluetooth is connected to the power supply. The "RDY" LED glows
green continuously. It takes about one to two minutes for the Sunny SensorBox to start up once
it is connected to the power supply. The blue Bluetooth LED on the SMA Power Injector with
Bluetooth glows continuously. Following initial startup, it can take three to four minutes before
the Sunny SensorBox is ready for use.
– If the "RDY" LED on the SMA Power Injector with Bluetooth does not light up or flash, refer
to section 11 ”Troubleshooting” (page 68).
– If the blue Bluetooth LED on the SMA Power Injector with Bluetooth does not glow
continuously, refer to section 11 ”Troubleshooting” (page 68).
The startup procedure of the Sunny SensorBox is complete. You can now detect the Sunny SensorBox
with a communication product (e.g., the Sunny WebBox with Bluetooth or Sunny Explorer) and view
the data collected by the sensors.
DANGER!
Risk of electrocution caused by the improper handling of electrical devices.
All work on electrical devices must be carried out by qualified personnel.