SMA Sensorbox - Manual (Page 29)

SMA Solar Technology AG Mounting the Device
Installation Guide Sensorbox-IEN100914 29
Mounting the RS485 Power Injector
1. Determine the mounting location based on the amount of available space.
2. Mark the position of the drill holes using the wall
mounting bracket as a guide.
3. Drill holes with a diameter of 6 mm at the marked
points and insert the wall anchors.
4. Attach the wall mounting bracket to the wall with two
screws.
5. Slide the RS485 Power Injector onto the wall
mounting bracket as shown in steps ① - ③ .
☑ The RS485 Power Injector is now mounted on the wall.