SMA Sensorbox - Manual (Page 72)

Parameters SMA Solar Technology AG
72 Sensorbox-IEN100914 Installation Guide
Anemometer
*
* If no anemometer is connected or the wind velocity exceeds the measurement range, "0" is displayed in these channels.
12.1.2 Configurable Parameters
Name Description
WindVel m/s wind velocity in m/s
WindVel km/h wind velocity in km/h
WindVel mph wind velocity in mph
Name Description Value / range Explanation Default
value
DevNam device name Text allocation of a user-defined
device name
TmpUnit unit of temperature °C degrees Celsius °C
K Kelvin
°F degrees Fahrenheit
WindUnit unit for wind velocity m/s m/s
km/h
mph
DevRs Sunny SensorBox
reset 0 ms … 255 ms for reset, enter "1" and save;
the specified parameter will
not be added and the LED in
the Sunny SensorBox remains
off for 60 seconds
0
RS485DI response delay of the
Sunny SensorBox to
the RS485 bus;
this parameter is only
visible if you are
logged in as an
"installer" in the
communication device 0 ms … 1.000 ms if you are using a Sunny Boy
Control/Plus, this parameter
must be set to "200 ms"; if you
are using a Sunny WebBox,
the response delay can be
reduced to "10 ms".
200 ms