SMA Sensorbox - Manual (Page 48)

Startup SMA Solar Technology AG
48 Sensorbox-IEN100914 Installation Guide
17. Thread the RS485 communication cable through
the lock nut and the cable gland and into the
enclosure of the Sunny SensorBox.
18. Remove 4 cm of cable sleeve from the RS485
communication cable that is connected to the
Sunny SensorBox.
19. Strip approx. 6 mm of insulation from the wires.
20. Twist the cable shield into one string. The cable
shield is only needed if another Sunny SensorBox is
connected.
21. Pull the insulating tube over the cable shield. Allow 4 cm of the cable shield to stick out of the
insulating tube.
22. Insert the detached cable shield into the terminal.