SMA STP 15000TL - Manual (Page 39)

8 Configuration
8.1 Configuration Procedure
Once you have commissioned the inverter, you may have to adjust various settings via the rotary
switches in the inverter or via a communication product. This section describes the procedure for
configuration and gives an overview of the steps you must perform in the prescribed order.
Procedure See
1. If the display language is not set correctly, adjust the set-
tings. Section 8.2, page 39
2. If the inverter is equipped with a Speedwire/Webconnect
data module, integrate the inverter in a Speedwire net-
work and register it in Sunny Portal, if necessary. Manual of the communica-
tion product at www.SMA-
Solar.com
3. To manage the PV system data or to set the inverter pa-
rameters, capture the inverter in a communication product. Manual of the communica-
tion product at www.SMA-
Solar.com
4. Change the system time and system password. Manual of the communica-
tion product at www.SMA-
Solar.com
5. If you would like to use the self-learning string-failure de-
tection, activate the string-failure detection. Section 8.4, page 41
6. Set the active power limitation in case of PV system control
failure. Section 8.5, page 41
7. Reduce the attenuation of ripple control signals. Section 8.6, page 42
8. For partially shaded PV modules and depending on the
given shading situation, you should set the interval at
which the inverter optimizes the MPP of the PV system. Section 8.7, page 42
8.2 Changing the Display Language
If the language for the country data set is not the language you want to use, you can change the
display language as follows:
Procedure:
1.
Danger to life due to high voltages
• Disconnect the inverter from all voltage sources and open the enclosure lid (see
Section 10, page 48).
8 Configuration SMA Solar Technology AG
Operating Manual 39 STP15-17TL-10-BE-en-10