ShoreLand'r 2x4W - Manual (Page 55)

®
61643-- Holy Roller Assembly
Made in the USA Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 0002878
www.shorelandr.com REV - 8/17/00
REF# PART# DESCRIPTION QTY
1 60972 ROLLER WITH MOLDED HUB 6IN ......... 8
2 61913-- ROLLERARM 1720 INBOARD ............... 1
3 0210127 CARR 3/8-24 X 3 W/1 THRD GR8 ............ 4
4 1310121 WASHER USS ALUMINUM FLAT 3/4 ....... 8
5 1440100 HEX LOCKNUT 3/8-24 GRA ..................... 4
6 1540350 BULL RING PLAIN ..................................... 8
7 S-3184 PLASTIC MOLDED SWIVEL BLOCK ........ 2
8 S-3368 INLINE ROLLERPIN 19 1/2 ....................... 4
9 S-3383 ROLLER BUSHING MOLDED ................... 8
10 S-3384 FLAT WASHER 2OD X 1.150ID ALUM ... 8
Roller Assembly:
Mount the 8-holy roller assembly to the rear crossmember in a
location that best fits your boat. Secure with 1/2” x 4-1/2” carriage
bolts and 1/2” flange lock nuts.
Roller Ajustment:
Place your boat on the trailer. Determine the spacing on the roller
rack. It may be necessary to adjust your roller rack either further in
or out from the position you ahve it assembnled. The boat must
be adjusted to miss any keel or strake which might be on your
particular boat.
IMPORTANT: The roller rack should be spaced as far apart as
possible for stability. This in most cases will also allow your boat to
be as low as possible on the trailer for better tgrailering, loading
and unloading.
Once the roller racks have been spaced properly for your boat,
position the boat on th trailer with the transom flush with the rear
of the rear roller rack.