beautypg.com

ShoreLand'r 0003858-3 User Manual

Accessory, 3” swing tongue assemblies for brake trailers

background image

Midwest Industries, Inc.

Ida Grove, IA 51445

800.859.3028

www.shorelandr.com

0003858

Page 1

08/28/07

ACCESSORY

3” Swing Tongue Assemblies for

Brake Trailers

The 3” brake swing tongue is designed to replace a straight tongue with brakesthat is already installed in a trailer. It DOES NOT include

the actuator. The actuator on the straight tongue will be used on the swing tongue.

The winch post assembly must never be attached to the swing section of the tongue. The tongue is available in two different length rear

sections to accommodate the mounting of the winch post. Choose the correct length that best adapts to the winch post setting for your

boat.

The straight tongue must be removed before the swing tongue can be installed. It must also be disassembled so the actuator and safety

chains on the straight tongue can be used on the new swing tongue.

Removing the Old Tongue from the Frame

• Remove the boat from the trailer.

• Measure the location of the winch post with respect to the frame

tongue channel before removing it so you will know where it

needs to be re-installed on the new tongue.

• Remove the winch post from the straight tongue.

• Disconnect the brake line from the side frame brake hose at the

coupling located at the rear of the tongue and pull the tongue

brake line brake hose out with the actuator when it is removed.

• Disconnect the solenoid wires from the wire harness.

• Remove the actuator from the straight tongue by removing the

attaching hardware. Once unbolted, remove the actuator and

brake hose assembly.

• Remove the safety chains from the straight tongue.

• Remove the wire harness because it will be re-installed in the

swing tongue.

• Loosen the ½” x 1 ½” bolt securing the rear of the tongue to the

frame. Remove the bolt completely. Loosen and remove the

½” x 4” hex bolt securing the tongue to the front of the frame

tongue channel. Note that the two mounting bolts just removed

with be used to mount the new swing tongue into the frame

tongue channel.

• Slide the tongue out the front of the tongue channel.