ShoreLand'r 3 NB Swing Tongue User Manual
Accessory, 3” swing tongue assemblies for non-brake trailers
Midwest Industries, Inc.
Ida Grove, IA 51445
800.859.3028
www.shorelandr.com
0003846
Page 1
08/16/07
ACCESSORY
3” Swing Tongue Assemblies for
Non-Brake Trailers
The 3” non-brake swing tongue assembly is a replacement tongue that can be installed in any 2x3 trailer frame that is not equipped with
a brake system. It will replace a standard tongue and allows the front 30” section of the tongue (including the coupler) to be swung to the
side so that it will fit in a shorter storage area.
The winch post assembly must never be attached to the swing section of the tongue. The tongues are available in two different length
rear sections to accommodate the mounting of the winch post. Choose the correct length that best adapts to the winch post setting for
your boat.
Removing the Old Tongue from the Frame
• Remove the boat from the trailer.
• Measure the location of the winch post with respect to the frame
tongue channel before removing it so you know where it needs
to be re-installed on the new tongue. Remove the winch post
assembly by removing the three-3/8” x 4” hex bolts.
• Remove the coupler from the front of the old tongue.
• Remove the safety chains by removing the bolts that attach
them to the old tongue.
• Remove the ½” x 1 ½” hex bolt holding the tongue cap and the
rear of the tongue into the tongue channel.
• Remove the ½” x 4” hex cross bolt that attaches the tongue in
the front of the tongue channel.
• Disconnect the side frame wire harnesses from the tongue har-
ness. Remove the tongue harness.
• Remove the old tongue assembly from the frame.
Installing the New Swing Tongue to the Frame
• Locate the new swing tongue and slide the rear section into the
frame tongue channel.
• Align the cross hole in the new tongue with the hole in the
frame tongue channel. Insert the ½” x 4” cross bolt just removed
through the aligned hole to secure it in position. Place on the
flange lock nut.
DO NOT tighten at this point.
• Route the tongue wire harness just removed down through the
hole in the top of the tongue, then backwards to the swing end.