ShoreLand'r 2x4W - Manual (Page 50)

Rocker Boxes:
Align the center hole of the 6239210, rocker arm, with the
center hole of the spring bracket. Secure with a 3/4” X 4-1/
2” hex bolt, from the outside-in, and 3/4” hex lock nut with
the grease zerk down.
Axles:
Fasten the springs to the axles with the axle u-bolts, spring
plate and hex lock nuts. NOTE: Make certain the hook end
of the springs point in the same direction to the rear of the
trailer, on both axles! For the rear spring and axle place a
S-3207 galvanized spring bracket bushing in the rear of
the spring bracket. Insert a 9/16” X 3-1/4” hex bolt through
the bracket from the outside-in and tighten with a 9/16” hex
lock nut. Slide the end of the hook spring over the bushing;
raise the front of the spring and fasten with a 9/16” X 3-1/4”
hex bolt and 9/16” hex lock nut.
For installation of the front spring and axle repeat the
above instructions, however, place the bushing in the
rocker box in hook end of the spring. Insert bolts and
secure with lock nuts as before.
Mount the tire and rim assemblies using 80-90 ft. lbs.
torque on the lug nuts.
Brakes:
Refer to the brake manual for service and maintenance.
Tire Size & Carrying Capacity Chart
Tire Load Carrying
Size Range Capacity
ST175/80R13 C 1360 lbs. per/tire
Refer to the tire side wall for the correct tire pressure.