ShoreLand'r 2x4W - Manual (Page 16)

Final Assembly Instructions
Remove the small parts from the frame by cutting the
bands. Remove the bolt bag and sort all nuts and bolts by
size.
Tongue:
Remove the tongue assembly from the frame bundle and
install into the tongue channel and secure with a 1/2” X 4”
hex bolt in the side of the tongue and tongue channel.
Secure with a 1/2” flange lock nut.
Place the tongue cover over the rear of the tongue and
tongue channel and secure with a 1/2” X 1-1/2” hex bolt,
1/2” flat washer and 1/2” hex nut.
Tongue Wires:
Install the tongue wire harness through the top forward
wire hole and exit the rear of the tongue channel on the
frame. Install grommets and plug the tongue wire into the
frame harness by color.
Actuator & Safety Chain:
Slide the actuator (Ref.#41) into the actuator housing unit
(Ref.#8) and secure with two pins and snap rings provided
with the actuator. Secure the actuator-housing unit to the
front of the tongue using three-(3) ½” X 4” hex bolts and ½”
flange lock nuts. Using a ½” X 5” hex bolt on lower right
mounting hole on tongue, secure the safety chain. Place a
½” flat washer on ½” X 5” hex bolt followed by one safety
chain and insert into actuator housing unit and tongue.
Place the second safety chain on the bolt followed by a ½”
flat washer and ½” flange lock nut. Tighten.
Brakes:
Refer to the brake manual for service and maintenance.
Roller Assembly:
Refer to Doc# 0002813 for assembly instructions.
Keel Roller:
Refer to Doc# 0002813 for assembly instructions.