HEIDENHAIN TNC 640 (34059x-04) - Manual (Page 62)

First Steps with the TNC 640
1.4 Graphically testing the first part
1
62
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
Starting the test run
Press the RESET + START soft key: The TNC
simulates the active program up to a programmed
break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the
STOP soft key: The TNC interrupts the
test run
Press the START soft key: the TNC resumes the
test run after an interruption.
Further information on this topic
Running a test run: See "Test Run", page 573
Graphic functions: See "Graphics ", page 562
Adjust the simulation speed: See "Speed of the Setting test
runs", page 563