HEIDENHAIN TNC 640 (34059x-04) - Manual (Page 590)

MOD functions
18.1 MOD function
18
590
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
18.1 MOD function
The MOD functions provide additional input possibilities and
displays. In addition you can enter code numbers to enable access
to protected areas.
Selecting MOD functions
Open the pop-up window with the MOD functions:
To select the MOD functions, Press the MOD key.
The TNC opens a pop-up window displaying the
available MOD functions.
Changing the settings
As well as with the mouse, navigation with the keyboard is also
possible in the MOD functions:
Switch from the input area in the right window to the MOD
function selections in the left window with the tab key
Select MOD function
Switch to the input field with the tab key or ENT key
Enter value according to function and confirm with
OK or make
selection and confirm with Apply
If more than one possibility is available for a particular
setting, you can superimpose a window listing all
of the given possibilities by pressing the GOTO key.
Select the setting with the ENT key. If you don't want
to change the setting, close the window again with
END.
Exiting MOD functions
To close the MOD functions, Press the CANCEL or END key