HEIDENHAIN TNC 640 (34059x-04) User Manual
Page 39
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
39
14 Programming: Turning Operations............................................................................................. 467
14.1 Turning Operations on Milling Machines (Software Option 50).....................................................468
Introduction........................................................................................................................................... 468
14.2 Basis Functions (Software Option 50).............................................................................................. 469
Switching between milling/turning mode of operation......................................................................... 469
Graphical display of turning operations.................................................................................................471
Program spindle speed......................................................................................................................... 472
Feed rate............................................................................................................................................... 473
Tool call..................................................................................................................................................473
Tool compensation in the program....................................................................................................... 474
Tool data................................................................................................................................................ 475
Tool tip radius compensation TRC........................................................................................................ 480
Recessing and undercutting..................................................................................................................481
Inclined turning......................................................................................................................................487
14.3 Unbalance Functions.......................................................................................................................... 489
Unbalance while turning....................................................................................................................... 489
Measure Unbalance cycle.....................................................................................................................491