HEIDENHAIN TNC 640 (34059x-04) - Manual (Page 575)

Program run 17.5
17
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
575
17.5 Program run
Application
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or up to a program
stop.
In the Program Run, Single Block mode of operation you must start
each block separately by pressing the machine
START button.
The following TNC functions are available in the program run
modes of operation:
Interrupt program run
Starting the program run from a certain block
Optional block skip
Editing the tool table TOOL.T
Checking and changing Q parameters
Superimposing handwheel positioning
Functions for graphic simulation
Additional status display