HEIDENHAIN TNC 620 (340 56x-03) ISO programming - Manual (Page 481)

HEIDENHAIN TNC 620 481
Touch probe cycles for datum setting
(manual and automatic cycles) Cycles can only be executed if the tilted
working plane function is inactive, the
datum shift is inactive and rotation with
Cycle 10 is inactive. As of version
34056x 03, touch probe cycles with
active coordinate transformations can
be used. No restrictions in connection with
coordinate transformations
PLANE function:
„ TABLE ROT /COORD ROT not defined „ Configured setting is used „ COORD ROT is used
„ Machine is configured for axis angle „ All PLANE functions can be used „ Only PLANE AXIAL is executed
„ Programming an incremental spatial
angle according to PLANE AXIAL „ Error message is issued „ Incremental spatial angle is
interpreted as an absolute value
„ Programming an incremental axis
angle according to PLANE SPATIAL if
the machine is configured for spatial
angle „ Error message is issued „ Incremental axis angle is interpreted
as an absolute value
Special functions for cycle
programming:
„ FN17 „ Function available, details are different „ Function available, details are different
„ FN18 „ Function available, details are different „ Function available, details are different
Function TNC 620 iTNC 530