HEIDENHAIN TNC 620 (340 56x-03) ISO programming - Manual (Page 411)

HEIDENHAIN TNC 620 411
16.1 Selecting MOD F
unctions
Overview of MOD functions
The functions available depend on the momentarily selected operating
mode:
Programming:
„ Displaying software numbers
„ Entering the code number
„ Machine-specific user parameters, if applicable
„ Legal information
Test run:
„ Displaying software numbers
„ Showing the active tool table in the test run
„ Showing the active datum table in the test run
In all other modes:
„ Displaying software numbers
„ Selecting position displays
„ Defining the unit of measurement (mm/inches)
„ Setting the programming language for MDI
„ Selection of axes for actual position capture
„ Displaying operating times