HEIDENHAIN TNC 620 (340 56x-03) ISO programming - Manual (Page 470)

470
Calling the file manager while the CYCLE
DEF
and TOUCH PROBE menus are active
Terminates the editing process and calls
the file manager. The respective soft-
key row remains selected when the file
manager is exited Error message Key non-functional
Calling the file manager while
CYCL CALL
, SPEC FCT, PGM CALL and
APPR/DEP menus are active
Terminates the editing process and calls
the file manager. The respective soft-
key row remains selected when the file
manager is exited Terminates the editing process and calls
the file manager. The basic soft-key row
is selected when the file manager is
exited
Datum table:
„ Sorting function by values within an
axis „ Available „ Not available
„ Resetting the table „ Available „ Not available
„ Hiding axes that are not present „ Not available „ Available
„ Switching the list/form view „ Switchover via split-screen key „ Switchover by toggle soft key
„ Inserting individual line „ Allowed everywhere, renumbering
possible after request. Empty line is
inserted, must be filled with zeros
manually „ Only allowed at end of table. Line with
value 0 in all columns is inserted
„ Transfer of actual position values in
individual axis to the datum table per
keystroke „ Not available „ Available
„ Transfer of actual position values in all
active axes to the datum table per
keystroke „ Not available „ Available
„ Using a key to capture the last
positions measured by TS „ Not available „ Available
„ Entry of comment in DOC column „ With the "Edit the current field"
function and the on-line keyboard „ Via ASCII keyboard
FK free contour programming:
„ Programming of parallel axes „ With X/Y coordinates, independent of
machine type; switchover with
FUNCTION PARAXMODE „ Machine-dependent with the existing
parallel axes
„ Automatic correction of relative
references „ Relative references in contour
subprograms are not corrected
automatically „ All relative references are corrected
automatically
Handling of error messages:
„ Help for error messages „ Call via ERR key „ Call via HELP key
„ Help for error messages while a block
is being edited „ Cause and corrective action cannot be
displayed while highlight is on the
block „ Pop-up window shows cause and
corrective action
„ Switching the operating mode while
help menu is active „ Help menu is closed when the
operating mode is switched „ Operating mode switchover is not
allowed (key is non-functional)
„ Selecting the background operating
mode while help menu is active „ Help menu is closed when F12 is used
for switching „ Help menu remains open when F12 is
used for switching
„ Identical error messages „ Are collected in a list „ Are displayed only once
Function TNC 620 iTNC 530