HEIDENHAIN TNC 620 (340 56x-03) ISO programming - Manual (Page 352)

352 Manual Operation and Setup
13.5 Using 3-D T
ouc
h Pr
obes
13.5 Using 3-D Touch Probes
Overview
The following touch probe cycles are available in the Manual Operation
mode:
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
If you use probing functions in a tilted working plane, you
must set 3-D ROT to Active for the Manual Operation and
Automatic operating modes.
Function Soft key Page
Calibrate the effective length Page 357
Calibrate the effective radius Page 358
Measure a basic rotation using a line Page 362
Set the datum in any axis Page 363
Set a corner as datum Page 364
Set a circle center as datum Page 365
Touch probe system data management See User’s
Manual for
Cycles
For more information about the touch probe table, refer to
the User’s Manual for Cycle Programming.