HEIDENHAIN TNC 620 (340 56x-03) ISO programming - Manual (Page 47)

HEIDENHAIN TNC 620 47
1
.4 Gr
aphically T
esting the First P
ar
t
1.4 Graphically Testing the First
Part
Selecting the correct operating mode
You can test programs only in the Test Run mode:
U Press the operating modes key: The TNC goes into
the Test Run mode
Further information on this topic
„ Operating modes of the TNC: See "Operating Modes" on page 60
„ Testing programs: See "Test Run" on page 395
Selecting the tool table for the test run
You only need to execute this step if you have not activated a tool
table in the Test Run mode.
U Press the PGM MGT key: The TNC displays the file
manager
U Press the SELECT TYPE soft key: The TNC shows a
soft-key menu for selection of the file type to be
displayed
U Press the SHOW ALL soft key: The TNC shows all
saved files in the right window
U Move the highlight to the left onto the directories
U Move the highlight to the TNC:\ directory
U Move the highlight to the right onto the files
U Move the highlight to the file TOOL.T (active tool
table) and load with the ENT key: TOOL.T receives
the status S and is therefore active for the Test Run
U Press the END key: Leave the file manager
Further information on this topic
„ Tool management: See "Entering tool data in the table" on page 135
„ Testing programs: See "Test Run" on page 395