HEIDENHAIN TNC 620 (340 56x-03) - Manual (Page 523)

HEIDENHAIN TNC 620 523
Comparison: Differences in programming
Function TNC 620 iTNC 530
Input of texts (comments, program
names, structure items, network
addresses, etc.) Input via screen keyboard Input via ASCII keyboard
Switching the operating mode while a
block is being edited Not permitted Permitted
PGM CALL , SEL TABLE, SEL PATTERN, SEL
CONTOUR : Selection of file in a pop-up
window
Available Not available
File handling:
„ Save file function „ Available „ Not available
„ Save file as function „ Available „ Not available
„ Discard changes „ Available „ Not available
File management:
„ Mouse operation „ Available „ Available
„ Sorting function „ Available „ Available
„ Entry of name „ Opens the Select file pop-up
window „ Synchronizes the cursor
„ Support of short cuts „ Not available „ Available
„ Favorites management „ Not available „ Available
„ Configuration of column structure „ Not available „ Available
„ Soft-key arrangement „ Slightly different „ Slightly different
Skip block function Insert/Remove by soft key Insert/Remove with ASCII keyboard
Selecting a tool from the table Selection via split-screen menu Selection in a pop-up window
Using the cursor in tables After editing a value, the horizontal
arrow keys can be used for positioning
within the column After editing a value, the horizontal
arrow keys can be used for positioning
to the next/previous column
Programming special functions with the
SPEC FCT key Pressing the key opens a soft-key row
as a submenu. To exit the submenu,
press the SPEC FCT key again; then the
TNC shows the last active soft-key row Pressing the key adds the soft-key row
as the last row. To exit the menu, press
the SPEC FCT key again; then the TNC
shows the last active soft-key row
Programming approach and departure
motions with the APPR DEP key Pressing the key opens a soft-key row
as a submenu. To exit the submenu,
press the APPR DEP key again; then the
TNC shows the last active soft-key row Pressing the key adds the soft-key row
as the last row. To exit the menu, press
the APPR DEP key again; then the TNC
shows the last active soft-key row
Pressing the END hard key while the
CYCLE DEF
and TOUCH PROBE menus are
active
Terminates the editing process and calls
the file manager Exits the respective menu