HEIDENHAIN TNC 620 (340 56x-03) - Manual (Page 408)

408 Manual Operation and Setup
13.5 Using 3-D T
ouc
h Pr
obes (T
ouc
h
P
robe F
u
nction Sof
tw
a
re
Option)
13.5 Using 3-D Touch Probes
(Touch Probe Function
Software Option)
Overview
The following touch probe cycles are available in the Manual Operation
mode:
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
If you use probing functions in a tilted working plane, you
must set 3-D ROT to Active for the Manual Operation and
Automatic operating modes.
Function Soft key Page
Calibrate the effective length Page 412
Calibrate the effective radius Page 413
Measure a basic rotation using a line Page 416
Set the datum in any axis Page 417
Set a corner as datum Page 418
Set a circle center as datum Page 419
Touch probe system data management See User’s
Manual for
Cycles
For more information about the touch probe table, refer to
the User’s Manual for Cycle Programming.