HEIDENHAIN TNC 620 (340 56x-03) - Manual (Page 422)

422 Manual Operation and Setup
13.8 D
a
tu
m Set
ting with 3-D T
ouc
h Pr
obe (T
ouc
h
P
ro
be
F
unction
Sof
tw
a
re
Option)
Finding the angle between the angle reference axis and a
workpiece edge
U Select the probe function by pressing the PROBING
ROT soft key
U Rotation angle: If you need the current basic rotation
later, write down the value that appears under
Rotation angle
U Make a basic rotation with workpiece edge to be
compared (see "Compensating Workpiece
Misalignment with 3-D Touch Probe (Touch Probe
Function Software Option)" on page 415)
U Press the PROBING ROT soft key to display the angle
between the angle reference axis and the workpiece
edge as the rotation angle
U Cancel the basic rotation, or restore the previous basic
rotation
U This is done by setting the rotation angle to the value
that you previously wrote down
To measure the angle between two workpiece edges:
U Select the probe function by pressing the PROBING ROT soft key
U Rotation angle: If you need the current basic rotation later, write
down the displayed rotation angle
U Make a basic rotation with first workpiece edge (see "Compensating
Workpiece Misalignment with 3-D Touch Probe (Touch Probe
Function Software Option)" on page 415)
U Probe the second edge as for a basic rotation, but do not set the
rotation angle to zero!
U Press the PROBING ROT soft key to display the angle PA between
the workpiece edges as the rotation angle
U Cancel the basic rotation, or restore the previous basic rotation by
setting the rotation angle to the value that you wrote down
previously
PA
–10
100
a?
a?
L?
X
Z
Y
100