HEIDENHAIN TNC 620 (340 56x-03) - Manual (Page 11)

HEIDENHAIN TNC 620 11
Chang
e
d F
u
nctions of Sof
tw
a
re
340
56x
-02
Changed Functions of Software
340 56x-02
„ In Cycle 22 you can now define a tool name also for the coarse
roughing tool (see User's Manual Cycles).
„ The additional status display has been revised. The following
improvements have been made (see "Additional status displays" on
page 67):
„ A new overview page with the most important status displays
was introduced.
„ The tolerance values set in Cycle 32 are displayed.
„ The pocket-, stud- and slot-milling cycles 210 to 214 were removed
from the standard soft-key row (CYCL DEF >
POCKETS/STUDS/SLOTS). For reasons of compatibility, the cycles
will still be available, and can be selected via the GOTO key.
„ With Cycle 25 Contour Train, closed contours can now also be
programmed.
„ Tool changes are now also possible during mid-program startup.
„ Language-sensitive texts can now be output with FN16 F-Print.
„ The soft-key structure of the SPEC FCT function was changed and
adapted to the iTNC 530.