HEIDENHAIN iTNC 530 (606 42x-02) - Manual (Page 573)

HEIDENHAIN iTNC 530 573
14.6 Using the 3-D T
o
uc
h Pr
obe
14.6 Using the 3-D Touch Probe
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Note that HEIDENHAIN generally does not accept liability
for the function of the touch probe cycles unless you use
HEIDENHAIN touch probes!
Function Soft key Page
Calibrating the effective length Page 578
Calibrating the effective radius Page 579
Measuring a basic rotation using a line Page 583
Setting the datum in any axis Page 587
Setting a corner as datum Page 588
Setting a circle center as datum Page 589
Setting a center line as datum Page 590
Measuring a basic rotation using two
holes/cylindrical studs Page 591
Setting the datum using four
holes/cylindrical studs Page 591
Setting a circle center using three
holes/cylindrical studs Page 591