HEIDENHAIN iTNC 530 (606 42x-02) - Manual (Page 332)

332 Programming: Q-Parameters
9.8 A
d
ditional F
unctions
9 W axis
Status of M128, 280 1 - 0: M128 inactive, value not equal to 0: M128 active
2 - Feed rate that was programmed with M128
Status of M116, 310 116 - 0: M116 inactive, value not equal to 0: M116 active
128 - 0: M128 inactive, value not equal to 0: M128 active
144 - 0: M144 inactive, value not equal to 0: M144 active
Current system time of the TNC,
320 1 0 System time in seconds that have elapsed since 00:00
of January 1, 1970
Status of global program
settings GS, 331 0 0 0: No global program setting is active, 1: A global
program setting is active
1 0 1: Basic rotation active, otherwise 0
2 0 1: Swapping axes active, otherwise 0
3 0 1: Mirroring axes active, otherwise 0
4 0 1: Shifting active, otherwise 0
5 0 1: Rotation active, otherwise 0
6 0 1: Feed rate factor active, otherwise 0
7 0 1: Disabling axes active, otherwise 0
8 0 1: Handwheel superimposition active, otherwise 0
Values from global program
settings GS, 332 1 0 Value of basic rotation
2 1 to 9 (X to W) Provides the index of the axis on which the queried
axis was swapped: 1=X, 2=Y, 3=Z, 4=Y, 5=B, 6=C,
7=U, 8=V, 9=W
3 1 to 9 (X to W) Provides 1 if the queried axis is mirrored
4 1 to 9 (X to W) Supplies the shift value of the queried axis
5 0 Provides the active rotation angle
6 0 Provides the active value of the feed-rate override
7 1 to 9 (X to W) Provides 1 if the queried axis is disabled
8 1 to 10 (X to VT) Provides the max. value of the handwheel
superimposition in the queried axis
9 1 to 10 (X to VT) Provides the actual value of the handwheel
superimposition in the queried axis
Group name, ID no. Number Index Meaning