HEIDENHAIN iTNC 530 (606 42x-02) - Manual (Page 13)

New functions 606 42x
-0
1 since the pr
edecessor v
e
rsions 340
49x
-05
HEIDENHAIN iTNC 530 13
New functions 606 42x-01 since the
predecessor versions 340 49x-05
„ Opening and Editing of externally created files is new (see
“Additional tools for management of external file types” on page
139)
„ New functions in the task bar added (see “Soft-key row” on page
92)
„ Enhanced functions for configuration of the Ethernet interface (see
“Configuring the TNC” on page 651)
„ Improvements regarding Functional Safety FS (option):
„ General information on Functional Safety FS (see “General
Information” on page 560)
„ Explanation of terms (see “Explanation of terms” on page 561)
„ Checking the axis positions (see “Check axis positions” on page
562)
„ Activating feed-rate limitation (see “Activating feed-rate
limitation” on page 564)
„ Improvements regarding the general status view of a TNC with
functional safety (see “Additional Status displays” on page 564)
„ The new HR 520 and HR 550 FS handwheels are supported (see
“Traversing with electronic handwheels” on page 548)
„ New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool’s contact angle on blocks with surface normal
vectors (LN blocks, see "3-D tool radius compensation depending on
the tool’s contact angle (3D-ToolComp software option)", page 515)
„ 3-D line graphics is now also possible in full-screen mode (see “3-D
Line Graphics (FCL2 Function)” on page 156)
„ A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see “Calling any
program as a subprogram” on page 291)
„ DCM: Saving and restoring of fixture situations
„ DCM: The form for test program generation now also contains icons
and tooltips (see “Check the position of the measured fixture” on
page 408)
„ DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
„ DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired.(see “Operating
FixtureWizard” on page 405)
„ DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
„ DCM: A library with standard chucking equipment is available now
(see “Fixture templates” on page 404)
„ DCM: Tool carrier management (see “Tool Holder Management
(DCM Software Option)” on page 413)
„ In the Test Run mode, the working plane can now by defined
manually (see “Setting a tilted working plane for the test run” on
page 626)