14 manual operation and setup – HEIDENHAIN iTNC 530 (606 42x-02) User Manual
Page 42
42
14.1 Switch-On, Switch-Off ..... 542
14.2 Moving the Machine Axes ..... 546
Moving the axis using the machine axis direction buttons ..... 546
Incremental jog positioning ..... 547
Traversing with electronic handwheels ..... 548
14.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 558
Changing the spindle speed and feed rate ..... 559
14.4 Functional Safety FS (Option) ..... 560
Explanation of terms ..... 561
Check axis positions ..... 562
Overview of permitted feed rates and speeds ..... 563
Activating feed-rate limitation ..... 564
Additional Status displays ..... 564
14.5 Datum Setting without a 3-D Touch Probe ..... 565
Workpiece presetting with axis keys ..... 566
Datum management with the preset table ..... 567
14.6 Using the 3-D Touch Probe ..... 573
Selecting probe cycles ..... 574
Recording measured values from the touch-probe cycles ..... 574
Writing the measured values from touch probe cycles in datum tables ..... 575
Writing the measured values from touch probe cycles in the preset table ..... 576
Storing measured values in the pallet preset table ..... 577
14.7 Calibrating a 3-D Touch Probe ..... 578
Calibrating the effective length ..... 578
Calibrating the effective radius and compensating center misalignment ..... 579
Displaying calibration values ..... 580
Managing more than one block of calibrating data ..... 580
14.8 Compensating Workpiece Misalignment with a 3-D Touch Probe ..... 581
Basic rotation using 2 points: ..... 583
Determining basic rotation using 2 holes/studs: ..... 585